No hay comentarios de productos.
THEFT PROTECTION
To �train� a new KeyCard in case of loss or damage:
Training a new KeyCard / Entering the master code
If you no longer have a valid KeyCard for your device, and would like to train a new KeyCard:
� Insert the first KeyCard and switch the
device on.
� Press the MENU button, 8. � Press the or button, 7, until
�LEARN KC� appears in the display.
� Insert the new, unknown KeyCard into
the device. � Close the control unit.
� Press the
button, 7.
� If necessary, switch the device off. � Hold down the TUNE and ST1 buttons,
> and 4, at the same time.
�CHANGE� appears in the display.
� Remove the first KeyCard. � Insert the new KeyCard.
�LEARN OK� appears in the display. To leave the menu:
� Switch the device on with the main button, 2. �0000� appears in the display. Enter the four-figure master code from the Car Radio Passport as follows:
� Press the MENU button, 8.
The radio can now be operated with the new KeyCard.
� Enter each of the numbers for the master code using the and buttons, 7, pressing until the desired number appears in the display.
KeyCard lost or damaged
If all the KeyCards belonging to a device are damaged or lost, a new KeyCard will have to be �retrained� with the device�s master code. You will find this code in the device�s Car Radio Passport. Keep your Car Radio Passport in a safe place, but never in the car itself. The instructions for this are in the section on �Training a new KeyCard / Entering the master code�. Using this KeyCard, you can then �train� a second KeyCard. Please read the section on �Replacing / Training KeyCards�. New KeyCards can be obtained from your dealer.
� To enter the next/previous digit, use the
and buttons, 7. � When the master code is correctly displayed, press the OK button, 5. If the device switches to play, the new KeyCard has been accepted.
Visual theft protection (LED)
When the device is switched off and the KeyCard has been removed, the power button and the CD slot illumination can be set to flash. This is done by setting �LED� to �ON� in the menu.
� Press the MENU button, 8. � Press the
or button, 7, until either �LED ON� or �LED OFF� appears in the display.
� Press the
or button, 7, to switch between the settings ON and OFF. button, 8, to leave the menu. The settings are then saved.
� Press the OK button, 5, or the MENU
8
