WHIRLPOOL NT17HX3GL
Manual de Usuario

10. Pry the plug cover from the plastic bushing at the top of the lower door and press into the plastic bushing on the opposite side of the door. 11. Remove the base grille by grasping at both ends and pulling it straight out. 12. Remove the lower hinge and spacer. 13. Rotate the lower hinge counterclockwise 90o and install it (including spacer) to the left leg of the cabinet.

*" 'N
,r-- l. _._..

NOTE: It will take extra effort to install the screws. The screws are self tapping and will have to cut threads in the screw holes. 14. Pull the metal hinge pin from the side of the lower hinge and place it, including the spacer washer, into the top hole. 15. Pry out the two screw hole plug buttons on the bottom left side of the top door and lower door. Press in the plug buttons in the holes on the right side of both doors. 16. Set the lower door on the bottom hinge, making sure the hinge pin enters the bushing in the door bottom. 17. While holding the door in a closed position, take the center hinge pin that was removed in step 8, and insert it through the left ho_eof the center hinge and into the bottom door bushing. Make sure the long pin goes into the bottom door and the short pin goes into the top door. 18. Set the upper door on the center hinge, making sure the hinge pin enters the door bushing. When you close this door, the gasket should hold it in place. 19. Making sure to use the same number o spacers that were originally used beneath the upper hinge, install the hinge mounting screws. Before tightening these screws, make sure the top of the door is level with the cabinet top, and the space between the door is equidistant across the entire front. Avoid overtightening these screws. Tighten both until they are just snug, then turn them in another one-half turn. 20. Examine the door gasket all around each door, making sure no gaps are visible between the gasket and cabinet. If a gap shows, try stretching the gasket away from the door so the magnet will contact the cabinet surface. 21. Remove the nameplates from the door handles and install them on the opposite handles as shown. To remove the nameplates, remove the front and back inserts from the metal handles. There is a hole in the front insert behind the nameplate. With the forefinger of the other hand bend the nameplate from the rear