AIWA NSXD22
Manual de Usuario

ECO mode
Reduces power consumption with the following operations, etc.
- The unit blacks out when the unit is turned off. Only the red indicator lights up. (Only when the clock is set.) - If dimmer mode is set to on, the unit illumination brightens (for 10 seconds) only when you operate the unit.

Dimmer
Adjusts the brightness of the display.
1 Press DEMO/ECO twice when the unit is turned on, and then within 4 seconds press ENTER. 2 Turn MULTI JOG to select one of the three dimmer modes or "DIM-OFF", and then press ENTER.
"DIM-OFF" is the brightest and "DIMMER 3" is the dimmest. If there is no MULTI JOG or button operation within 4 seconds, the setting is canceled. To cancel the dimmer Repeat the above and select "DIM-OFF".

Setting the clock
1 Press CLOCK on the remote control.
When the unit is turned off, you can also press aSET.

2 Press f or g to set the time.
Each press changes the time in 1-minute steps. Holding it down changes the time in 10-minute steps. If f or g is not pressed within 4 seconds, the setting is canceled. �MULTI JOG is also available in place of f or g.

En

1 Press DEMO/ECO once when the unit is turned on, and then within 4 seconds press ENTER. 2 Turn MULTI JOG to select "ECO ON" and then press ENTER.

3 Press aSET or ENTER.
The time display stops flashing and the clock starts from 00 seconds. To display the time Press CLOCK on the remote control. The time will be displayed for 4 seconds, but it cannot be displayed during recording. To switch to the 24-hour standard Display the time and press s within 4 seconds. With each press, the clock alternates between the 12-hour standard and the 24-hour standard.

If there is no MULTI JOG or button operation within 4 seconds, the setting is canceled.

To cancel the ECO mode Repeat the above and select "ECO OFF".

Tip: In the 12-hour standard, "AM 12:00" indicates midnight and "PM 12:00" noon.
If the clock display flashes when the unit is turned off There has been a power interruption. Re-set the clock.

9