5.6. Turntable motor 1. Remove the motor cover by cutting at the locations indicated by the arrows with a cutter.
NOTE:
After removing the motor cover, be sure that cut portions are properly trimmed or bent to the inside so that no sharp edges will be exposed to outside. 2. Disconnect 2 lead wires connected to the turntable motor. 3. Remove the turntable motor by removing screw.
NOTE:
After replacing the new turntable motor and reconnecting the two lead wires, reinstall the motor cover by rotating it 180°, tucking the tabs into the base in the 2 provided slots, then screw the single tab to the base using a 4mm X 6mm screw (not provided). /
