SONY MZN10
Manual de Servicio

MZ-N10 SECTION 4 TEST MODE
Outline
� This set provides the Overall adjustment mode that allows CD and MO discs to be automatically adjusted when in the test mode. In this overall adjustment mode, the disc is discriminate between CD and MO, and each adjustment is automatically executed in order. If a fault is found, the system displays its location. Also, the manual mode allows each individual adjustment to be automatically adjusted. � Operation in the test mode is performed with the set. A key having no particular description in the text, indicates a set key. � For the LCD display, the LCD on the remote commander is shown, but the contents of LCD display on the set are same. (Both displays may be displayed.) 3 In case of setting the test mode by keys on the set and remote commander: In the normal mode, turn on the [HOLD] switch on the set. While pressing the x key on the set, press the keys on the remote commander with the following order: >t>t.t.t>t .t>t.t t
Note: If electrical adjustment (CD and MO overall adjustment) has not been finished completely, �ERROR� is displayed on LCDs of the set and the remote commander.

Operation in Setting the Test Mode
� When the test mode becomes active, first the display check mode is selected. � Other mode can be selected from the display check mode. � When the test mode is set, the LCD repeats the following display.

Setting Method of Test Mode
There are three different methods to set the test mode: 1 Short SL803 (TEST) on the MAIN board with a solder bridge (connect pin <zx. of IC801 to the ground) and turn on the power.
� MAIN Board (Side B) �

Remote commander LCD display

All lit

All off

Microcomputer version display

V1.100

Set LCD display

All lit

IC801

All off
TP1829

1-686-347-

Microcomputer version display

001

R838

C815

Ver 1.100

SL803 (TEST)

2 In case of setting the test mode only by keys on the set: In the normal mode, turn on the [HOLD] switch. While pressing the [GROUP] key press the following order: >t>t.t.t>t .t>t.tXtX

� When the X key is pressed and hold down, the display at that time is held so that display can be checked.

Releasing the Test Mode
For test mode set with the method 1: Turn off the power and open the solder bridge on SL803 (TEST) on the MAIN board.
Note: Remove the solders completely. Remaining could be shorted with the chassis, etc.

For test mode set with the method 2 or 3: Turn off the power.

11