SONY MZE35
Manual de Usuario

SECTION 3 TEST MODE
General � In the TEST mode, this set provides the Auto mode in which both CD and MO are adjusted automatically. In the Auto mode, whether a disc is CD or MO is discriminated, then each adjsutment is automatically executed sequentially. If a fault is found, it is displayed. Also, in the Servo mode, each item can be adjusted automatically. Entering TEST Mode Bridge the TAP801 (TEST) on MAIN board (connect IC801 #� to GND), and turn the power on. Then, press ( key and the TEST mode is activated. Releasing TEST Mode Turn the power off, and remove the bridge from TAP801 (TEST) on MAIN board. Operation in TEST Mode In the TEST mode, the LCD display is as shown below:
( ) for Remote controller LCD display

Configuration of TEST Mode The TEST mode configuration of this set is as follows:
+key
pkey

AUTO Mode (key (Auto?)
pkey

(Start?)
pkey

�key
pkey

MANUAL Mode (Manu?)

(key

SERVO Mode

000
+,�key AUDIO Mode

100
+,�key POWER Mode

300

300

Main unit LCD

300

V3.000

ROM version display (Ver3.00 or Ver3.20)

Remote controller LCD

SERVO Mode � Enter the TEST mode, press VOL � key and ( key to select the SERVO mode. � When the second digit of mode number is not 0 and the first digit is 0 (010, 020, 030, etc.), the optical pickup moves to outside track or inside track with + key or = key respectively. � To select other modes, refer to the TEST mode configuration. 1. Configuration of SERVO Mode
SERVO Mode
(key

Display in TEST Mode

� ROM version display � All ON � All OFF are repeated. � To hold the display for confirmation, press the PLAY MODE key.

000
pkey

+,�key

OFFSET Adj.

(key

010
Each time (key is pressed, 011-013 modes pkey are switched. (For each mode, see relevant table)
(key

pkey

LASER POWER Adj.

(key

020
Each time (key is pressed, 021-024 modes pkey are switched. (For each mode, see relevant table)
(key pkey

MO Adj.

(key

030
Each time (key is pressed, 031-039 modes pkey are switched. (For each mode, see relevant table)
(key

1

2
(To page 9 )

3

�8�

+,�key