SONY MZE32
Manual de Servicio

MZ-E33

6-4. SCHEMATIC DIAGRAM � Refer to page 25 for IC Block Diagrams. � Waveforms
MINIDISC OPTICAL PICK-UP BLOCK

(MODE:PLAY)

1
* : The electrical components differ according to the version of the system control IC (IC801). When replacing the IC801, check its model name and add or remove D1001 and/or R1001 as shown below. RU6815MF-0004 (Ver 3.0) .... Add D1001 and R1001 RU6815MF-0005 (Ver 3.2) and later .... Remove D1001 and R1001

800mVp-p

IC501 @� TIME/DIV : 5 µsec

VOLT/DIV : 200mV AC

2
2.7Vp-p

23 µsec

IC601 #ª TIME/DIV : 10 µsec

VOLT/DIV : 1V AC

3
2.6Vp-p

482nsec

IC601 $¡ TIME/DIV : 200nsec

VOLT/DIV : 500mV AC

4
2.0 Vp-p

16.9344 MHz

IC601 $ª TIME/DIV : 20nsec

VOLT/DIV : 500mV AC

Note: � All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums. � All resistors are in � and 1/4 W or less unless otherwise specified. Note: The components identified by mark ! or dotted line with mark ! are critical for safety. Replace only with part number specified. � A : B+ Line. � Power voltage is dc 3 V and fed with regulated dc power supply from battery terminal. � Voltage and waveforms are dc with respect to ground under no-signal conditions. no mark : MD PLAY � Voltages are taken with a VOM (Input impedance 10 M�). Voltage variations may be noted due to normal production tolerances. � Waveforms are taken with a oscilloscope. Voltage variations may be noted due to normal production tolerances. � Signal path. J : MD

� 21 �

� 22 �

� 23 �

� 24 �