MX-KA66
<Disassembly of units and assembly inside this set>
Removing the CD PCB (See Fig.12 to 13)
Prior to performing the following procedures, remove the top cover. Also remove the CD changer unit. 1. Disconnect the wires from CN603A, CN603B and CN604 on the CD PCB, which is located on the back side of the CD changer unit. 2. The four screws J that retain the CD PCB should be removed. 3. Remove the CD PCB by pulling it toward the side where the CN601 is located. 4. Using solder, short the CD pickup to connect to short round. [Caution] After re-connecting the wires, be sure to remove the shorting solder from the GND connection. 5. Disconnect the card wire from the connector CN601 on the main PCB and then remove the main PCB.
