JVC MX-GT95VUS
Manual de Usuario

English

Common Operations
Turning On or Off the Power
To turn on the unit, press STANDBY/ON so that the STANDBY lamp goes off.

To check the clock time
Press and hold SET/DISPLAY while playing any source. � Each time you press and hold the button, the source indication and the clock time alternate on the display.

To adjust the clock again
If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected. � Each time you press the button, the clock/timer setting modes change as follows:
DAILY Canceled ON TIME Clock setting REC ON TIME

To turn off the unit (on standby), press STANDBY/ON again so that the STANDBY lamp lights up.

� A little power is always consumed even while the unit is on standby. To switch off the power supply completely, unplug the AC power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs The clock is reset to �0:00� right away, while the tuner preset stations (see page 12) will be erased in a few days.

(The hour digits start flashing.)

When you unplug the AC power cord or if a power failure occurs The clock loses the setting and is reset to �0:00.� You need to set the clock again.

Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.

Setting the Clock
Before operating the unit any further, first set the built in clock. You can set the clock whether the unit is on or off.

On the unit ONLY:
You can only change the AM tuner interval spacing while tuning into an AM station. (See page 12.) Press STANDBY/ON while holding down 7. � Each time you press these buttons, the AM tuner interval spacing alternates between 9 kHz and 10 kHz.

On the unit ONLY:

1 Press CLOCK/TIMER.
The hour digits start flashing on the display.

2 Turn 4/¢ to adjust the
hour, then press SET/ DISPLAY.
The minute digits start flashing on the display.

Selecting the Sources
To listen to the FM/AM broadcasts, press FM/AM. (See page 12.) To playback CDs, press CD 3¥8 SELECT. (See pages 13 � 16.) To playback tapes, press TAPE 2 3. (See page 21.) To select the external equipment as the source, press AUX.

� If you want to correct the hour after pressing SET/DISPLAY, press CANCEL/DEMO. The hour digits start flashing again.

3 Turn 4/¢ to adjust the minute, then
press SET/DISPLAY.

When you press the play button for a particular source (FM/AM, CD 3/8 SELECT, TAPE 2 3, and AUX), the unit turns on (and the unit starts playing the source if it is ready � COMPU PLAY CONTROL).

About the audio level indicator All the audio level indicators light up when no signals come in.

�9�