SHARP MX-2700N
Manual de Servicio

2)

Remove the waste toner bottle unit.

6)

Hold the lock lever, and pull out each color drum unit slowly, and support the lower section of the unit with both hands to remove.

1

2

3)

Loosen the blue screw. Check to confirm that lock is released, and open the drum positioning unit.

a. OPC drum 1) 2) Remove each drum unit from the machine. Remove the screws and remove the DR fixing shaft AS.

2

1

NOTE: When the transfer belt tension of the primary transfer unit is released manually, turn on the power again after completion of the work. (Power OFF-ON) This procedure initializes the transfer roller to return it to the home position. 4) Loosen the fixing screw of the developing unit on the left side of each color drum unit.

3)

Slide the OPC drum to the front side, and lift the drum rear side, and remove the OPC drum from the hole in the front section.

1 2

b. MC charger unit 1) 5) Remove the developing unit with both hands. 2) 3) Remove each drum unit from the machine. Remove the OPC drum. Remove the screws, and remove the MC cover.

1

2

MX-2300/2700 N/G PHOTOCONDUCTOR SECTION i � 4