BROTHER MX2003
Manual de Servicio

Note: When replacing/reassembling the infrared LED harness and MX ground wire, ensure that the cable length for the main frame R side as follows;
Infrared LED harness: 130 ± 5mm
MX ground wire: 65 ± 5mm
3.3.6 (1) Actuator A/B Release the hook on the right hand side on the rear cover B to remove it.
Main frame R

hook

Main frame R

Rear Cover B

Main frame L

Fig. 3.24

(2)

Remove the five idle gears 34, five swing arms and two gears 24 from the main frame R. Idle Gear 34
Swing arm Idle Gear 34 Swing arm

Swing arm

Idle Gear 34 Main frame R Idle Gear 24

Swing arm

Projection mark Main flap shaft Projection mark Fig. 3.25

Note: When reassembling the swing arm onto the main flap shaft, refer to the figure above.
III-15