TOSHIBA MW24FN1
Manual de Servicio

DISASSEMBLY INSTRUCTIONS
2-10: CASSETTE OPENER/PINCH ROLLER BLOCK/P5 ARM ASS�Y (Refer to Fig. 2-10-A) 1. Unlock the support 1 and remove the Cassette Opener. 2. Remove the Pinch Roller Block and P5 Arm Ass�y.
1
Cassette Opener

Spring Position Pinch Roller Block

Fig. 2-11-B

P5 Arm Ass�y

2-12: FE HEAD (RECORDER ONLY) (Refer to Fig. 2-12) 1. Remove the screw 1. 2. Remove the FE Head.
1

Main Chassis

Fig. 2-10-A NOTE 1. Do not touch the Pinch Roller. (Use gloves.) 2. In case of the Pinch Roller Block and the Pinch Roller Cam installation, install correctly as Fig. 2-10-B.

FE Head

Pinch Roller Block

Can be seen the hole of the Pinch Roller Cam.

P5 Arm Ass�y

� Screw Torque: 5 ± 0.5kgf�cm � The FE Head is not installed on the Video Cassette Player.

Fig. 2-12

Can be seen the hole of the Main Cam.

2-13: AHC ASS'Y/CYLINDER UNIT ASS'Y (Refer to Fig. 2-13) Fig. 2-10-B 1. Unlock the support 1 and remove the AHC Ass'y. 2. Disconnect the following connector: (CD2001) 3. Remove the 3 screws 2. 4. Remove the Cylinder Unit Ass'y. NOTE 1. When you install the Cylinder Unit Ass'y, tighten the screws from (1) to (3) in order while pulling the Ass'y toward the left front direction.

2-11: A/C HEAD (Refer to Fig. 2-11-A) 1. 2. 3. 4. Remove the screw 1. Remove the A/C Head Base. Remove the 3 screws 2. Remove the A/C Head and A/C Head Spring.

NOTE 1. Do not touch the A/C Head. (Use gloves.) 2. When you install the A/C Head Spring, install as shown in Fig. 2-11-B. 3. When you install the A/C Head, tighten the screw (1) first, then tighten the screw (2), finally tighten the screw (3).
(1) (3)

Cylinder Unit Ass'y

2 2
(2)

2 1
A/C Head

AHC Ass'y

A/C Head Spring (3)

1
(1) A/C Head Base � Screw Torque: 5 ± 0.5kgf�cm (Screw 1)

(2)

2 2

2
� Screw Torque: 3 ± 0.5kgf�cm

Fig. 2-13

Fig. 2-11-A B2-4