PIONEER MJ-D707/NV
Manual de Servicio

MJ-D707, MJ-17D

7.2 DIAGNOSIS
7.2.1 DISASSEMBLY Removal of the Servo Mechanism Assy
1 Remove the screw A. 2 Disconnect the connectors (CN102, CN103, CN105), open the hook of part A, and tilt the upper side of the CORE MAIN UNIT ASSY to the front. CN105 3 Disconnect the connector (CN101) at the rear of the CORE MAIN UNIT ASSY and remove the CORE MAIN UNIT ASSY. 4 After the Carrier has been pushed in, move the Upper Slider to Screw A the rear and stop it at the position where the Under Slider starts to move.

2

CN103

1

2
CN101

Part A

CN102

4
Rear Side

Upper Slider

2

3

CORE MAIN UNIT ASSY

Carrier

Move

5 Shift part B to the position shown in the figure while raising the Under Slider. (At the same time, the Upper Slider moves to the front.) 6 Remove the Lock Plate. (One screw B)

Under Slider

Under Slider Upper Slider

5

Part B

7 Remove the Servo Mechanism Assy.

Screw B

6

Lock Plate

Servo Mechanism Assy

Caution for the time of installation of the servo mechanism assy
Move the MD Pick-up to the innermost circumference. After installation of the servo mechanism assembly, shift the Upper Slider to the rear. (The Under Slider moves at the same time, and the servo mechanism assy is fixed. When the Under Slider is slide, this becomes the reason for switching ring catching.)

7
61