PIONEER MJ-D508/NVXJ
Manual de Servicio

MJ-D508

7.1.2 DISASSEMBLY Removal of the Servo Mechanism Assy
1 Remove the screw A and screw B. 2 Disconnect the connectors (CN102, CN103, CN105), open the hook of part A, and tilt the upper side of the CORE MAIN UNIT ASSY to the front. 3 Disconnect the connector (CN101) at the rear of the CORE MAIN UNIT ASSY and remove the CORE MAIN UNIT ASSY. 4 After the Carrier has been pushed in, move the Upper Slider to the rear and stop it at the position where the Under Slider starts to move.

2
CN105 Screw A

2 1
Screw B CN101 CN102

Part A

2 CN103 3

1
CORE MAIN UNIT ASSY

5 Shift part B to the position shown in the figure while raising the Under Slider. (At the same time, the Upper Slider moves to the front.) 6 Remove the Lock Plate. (One screw B)

Under Slider Upper Slider

4

Part B

Screw C

5
7 Remove the Servo Mechanism Assy.

Lock Plate

Servo Mechanism Assy

Caution for the time of installation of the servo mechanism assy
Move the MD Pick-up to the innermost circumference. The servo mechanism assembly is not installed other than the innermost circumference.

6
52