20. TURNTABLE OFF. Touch this pad to
stop the turntable only during the WARM HOLD and cook time functions. Stop the turntable only if the dish you are using is too long to turn inside the oven. To stop the turntable, touch TURNTABLE OFF before touching START/ENTER. The red light on the TURNTABLE OFF pad will come on. If you do not program a function within 1 minute of pressing TURNTABLE OFF, the turntable will automatically turn back on and the red light will go off. To turn the turntable back on, touch TURNTABLE OFF at any time during the programmed cycle. See pages 12, 13, and 45 for more turntable information.
21. LIGHT. Touch this pad to turn on the
cooktop/countertop light. See page 20 for more information. 22. FAN. Touch this pad to turn the fan on or off. See page 18 for more information. NOTES:
l
If you have entered all settings for a
function but do not touch the START/ ENTER pad within 5 seconds, the Start? indicator light will appear.
l
If you open the door while the oven is on
and then shut the door, the Start? indicator light will appear. Touch the START/ ENTER pad to restart the oven. If you choose a function but do not press another Command Pad within 1 minute, the display returns to the time of day and you must start over.
l
Audible
signals
Interrupting
cooking
Audible signals are available to guide you when setting and using your oven: l A programming tone will sound each time you touch a pad.
l
You can stop the oven during a cycle by opening the door. The oven stops heating and the fan stops, but the light stays on. To restart cooking, close the door and
l
l
l
One long tone signals the end of a Minute Timer countdown. Four tones signal the end of a cooking cycle. Two tones sound once every minute after an End-of-Cooking signal as a reminder if food has not been removed from oven. Three tones sound if you have made an incorrect entry.
TOUCH
If you do not want to continue cooking: Close the door and the light goes off. l OR
l
To disable all audible signals: l Touch and hold Number Pad 1 for
4 seconds to disable all programming tones.
TOUCH
To turn all signals back on:
Repeat step under �To disable all audible signals� above.
NOTE: Three tones, followed by two tones,
will sound when audible signals are turned on or off. The three tones will be omitted if all tones are disabled.
