Once removed, the components given in this subsection require the purge unit adjuster for reassembly. Refer to Section 3, "ADJUSTMENT" in this chapter.
After the main PCB is replaced with any other one, you need to replace the ink absorbers with new ones. (1) Pull out the ink absorbers from the drain tank. NOTE: Use vinyl gloves to prevent your hands from becoming dirty. (2) If the main chassis or the surrounding parts are stained with ink, wipe them with a waste cloth.
n
Reassembling Notes � When setting ink absorbers into the drain tank, use a screwdriver and the like.
1.30 Drain Tank
Caution
Once removed, the components given in this subsection require the purge unit adjuster for reassembly. Refer to Section 3, "ADJUSTMENT" in this chapter.
(1) Remove the screw and lift up the drain tank from the bottom plate.
