SONY MDS-NT1
Manual de Usuario

System Limitations (continued)
The total recorded time and the remaining recordable time on the MD may not total the maximum recording time
Recording is done in minimum units of 2 seconds* each, no matter how short the material. The contents recorded may thus be shorter than the maximum recording capacity. Disc space may also be further reduced by scratches.
* When recording in stereo mode. (Approx. 4 seconds in mono or LP2 mode, and approx. 8 seconds in LP4 mode.)

Troubleshooting
If you experience any of the following difficulties while using the deck, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. The deck does not operate or operates poorly. � The MD may be dirty or damaged. Replace the MD. � When the MD deck is connected to a computer and the operating system is running, you can only use the x/Z button (for ejecting the MD while the deck is stopped). The deck does not play. � Moisture has formed inside the deck. Take the MD out and leave the deck in a warm place for several hours until the moisture evaporates. � The deck may not be connected to the amplifier correctly. Check the connection. � The MD is inserted in the wrong direction. Slide the MD into the disc slot with the label side up and the arrow pointing towards the slot. � The MD may not be recorded. Replace the disc with one that has been recorded. The sound has a lot of static. � Strong magnetism from a television or a similar device is interfering with operations. Move the deck away from the source of strong magnetism. The deck does not record. � The MD is record-protected. Slide the recordprotect tab and close the slot. � The deck is not connected properly to the computer. Check the connection. � A premastered MD is inserted. Replace it with a recordable MD. � There is not enough time left on the MD. Replace it with another recordable MD with fewer recorded tracks, or erase unnecessary tracks. � There has been a power failure or the AC power adaptor has been disconnected during recording. Data recorded to that point may be lost. Repeat the recording procedure.

Tracks created through editing may exhibit sound dropout as you�re searching for a point while monitoring the sound. Some tracks can�t be combined with others
Tracks may not be combined if they have been edited.

The playback indicator flashes for a long time
If the inserted recordable MD is brand new, the playback indicator flashes longer than for MDs that have already been used.

10GB