Recording to an MD
If the MD has been partially recorded, recording starts after the recorded tracks.
To change the display while recording
Press LEVEL/DISPLAY/CHAR (or DISPLAY) repeatedly to change the display. Each time you press the button, the display changes cyclically as follows: Track number and recorded time of the current track t Remaining recordable time2) on the MD t Level of the input signal t Track name3)
2) Time shown in the display differs depending on the setting of REC MODE. 3) �No Name� appears when the track has no name.
1 Turn on the amplifier and program
source, and select the source on the amplifier.
2 Press ?/1 to turn on the deck.
The STANDBY indicator turns off.
3 Load a recordable MD into the slot
(page 15).
4 Press INPUT repeatedly to select the
input jacks (connector) connected to the program source. When the source is connected to the DIGITAL OPTICAL IN connector ANALOG IN jacks Set INPUT to
Notes on recording
After recording
D-IN A-IN
5 Press REC z.
The deck changes to recording pause.
Press EJECT A to remove the MD or press ?/1 to turn off the deck. �TOC� or �TOC Writing� starts flashing. The TOC is updated and recording is completed.
Before disconnecting the AC power cord
6 Adjust the recording level if necessary.
For details, see �Adjusting the recording level� on page 12. Recording starts.
7 Press H or X. 8 Start playing the program source.
Operations you may want to do during recording To Stop recording Pause recording Resume recording after pausing1) Eject the MD Press x X H or X EJECT A after stopping recording
MD recording is completed when the MD Table of Contents (TOC) is updated. The TOC is updated when you eject the MD or press ?/1 to turn off the deck. Do not disconnect the AC power cord before updating the TOC (while �TOC� is lit) or while updating the TOC (while �TOC Writing� is flashing) to ensure a complete recording.
Automatic conversion of digital sampling rates
A built-in sampling rate converter automatically converts the sampling frequency of various digital sources to the 44.1 kHz sampling rate of the MD deck. This allows you to monitor and record sources such as 32 or 48 kHz DAT tape or satellite broadcasts, as well as the CDs and MDs.
