SHARP MDR3
Manual de Usuario

(Continued)
ENTER

DELETE/CLEAR TIMER

REC LEVEL
MIN

s Timer recording
Before timer recording, the following preparations are required. q Load a recordable MD.

MAX

1 While in the stop mode, press the TIMER button, and then
turn the jog dial until "TIMER SET" appears.

2 Within 10 seconds, press the ENTER button, and then select
"TIMER REC" using the jog dial.

1 2 3
AM

3 Press the ENTER button.
q The start time setting display will appear.

4 Enter the �hour�, using the jog dial. Then, press the ENTER
button.

5 Enter the �minute�, using the jog dial. Then, press the ENTER
button. q The stop time setting display will appear.

6 Enter the �hour�, using the jog dial. Then, press the ENTER
button.

4

AM

7 Enter the �minute�, using the jog dial. Then, press the ENTER
button. q The start and stop times are now set.

AM

8 Select the source program using the jog dial.

5

AM

ANALOG � DIGITAL OPT � DIGITAL COAX q If you select the analog input, adjust the recording level. (Page 22)

AM

9 Press the ENTER button.
Setting timer for recording:

q The stop time setting display will appear. q The �hours� display will be automatically increased one hour.

1 Press the TIMER button, and then select "T-STANDBY" using

6

AM

the jog dial.

AM

2 Press the ENTER button.
q The settings will appear in order, and the unit will enter the timer recording stand-by mode. (The power will be turned off.)

7

AM

Preparations for any equipment connected to this unit Any equipment, such as a stereo, that is connected to this unit should be set up in advance as follows: q Set it up so that music to be recorded will be played at the same time as the timer�s start time. When the digital optical input was selected

8

1
(Timer stand-by mode)

2

TIMER REC

Timer recording indicator

37