SHARP MDMT200HS
Manual de Servicio

MD-MT200H

OPERATION MANUAL

Using with the Rechargeable Battery
s Charging the rechargeable battery
Do not force the battery cover open too far. Insert the � side first.
When the rechargeable battery is used for the first time or when you want to use it after a long period of disuse, be sure to charge it fully.

1 2 3

Insert the rechargeable battery. A rechargeable battery other than the AD-N55BT cannot be charged. Plug the AC adaptor into the wall socket, and then insert the plug on the other end into the DC IN 5V socket. Press the MENU/CHRG button. The battery indicator will scroll, and the battery will begin charging.

Scrolling

AC 230V, 50/60Hz

q

To the DC IN 5V socket

q

After the rechargeable battery is charged or used, it will get slightly warm. This is normal. When the portable MD is turned on or operating, the battery will not be charged.

Using with the Alkaline Battery
Use one commercially available alkaline battery (LR6, "AA" size).
Back of the portable MD
2

2 3

Insert an alkaline battery into the battery case. Attach the battery case to the portable MD.

Open

1 Press

RELEASE

LOCK

When using the alkaline battery, be sure to insert the rechargeable battery also.

1

Open the case cover.

Caution: q Whilst you are using the rechargeable battery and the alkaline battery at the same time, do not remove either of them. If you do, when the unit is in the play mode, playback will stop. When in the recording mode, the recorded contents will be erased, and the power may be disconnected. q Do not replace the battery or the rechargeable battery during operation. q Do not use a rechargeable battery (nickel-cadmium battery etc.) in the battery case. q If the unit is not used for a long period of time, remove the battery. (Even if the power is turned off, the battery will be drained slowly but continuously.)

Inserting a MiniDisc
2 3 4
Recordable Recording prevented When you record on a MiniDisc, check that the erase prevention tab is set to the "Recordable" position.

Lift it up. Insert a MiniDisc as shown. Close the compartment door.

1

Slide the OPEN lever to release the compartment door.

Notes: q Do not place the MiniDisc under the holder. q If any resistance is felt, do not force the MiniDisc into the unit, as it may cause damage to the unit. If resistance is felt, remove the MiniDisc and reload it. q The lid cannot be opened if "TOC" is displayed.

�5�