SHARP MD-80HBL
Manual de Servicio

MD-MT80H/90H/45H

OPERATION MANUAL

Battery Power
s Charging the rechargeable battery
When a separately available rechargeable battery is used for the first time or when you use it after a long period of disuse, be sure to charge it fully.

1

Insert the rechargeable battery.
A rechargeable battery other than the AD-N70BT cannot be charged.(MD-MT80H/45H) A rechargeble battery other than the one supplied or the optional one (AD-N70BT) cannot be charged.(MD-MT90H)

Illustration: MD-MT80H

2 3

Plug the AC adaptor into the wall socket, and then insert the plug on the other end into the DC IN 5V socket. Press the MODE/CHRG button.
" " will flash, and battery will begin charging.

q After the rechargeable battery is charged or used, it will get slightly warm. This is normal. q When the portable MD is turned on or operating, the battery will not be charged.

AC 220-230V 50/60 Hz (For U.K.) (For Europe)

s Checking the remaining amount of battery level
The remaining amount of battery level is shown by the battery indicator ( ) during operation.

s Using with the rechargeable or alkaline battery

1 2

Disconnect the AC adaptor. Insert the rechargeable battery or alkaline battery from the (+) marked side.
Use a commercially available LR6, "AA" size alkaline battery.

q When the battery is completely discharged, the battery indicator will flash. Recharge the battery or replace the alkaline battery with a new one. q When the battery has run completely out, "BATT EMPTY" will appear. Then, the power will be disconnected automatically. Notes: q If you use the battery which you stopped charging halfway, " " may appear. It does not mean that the battery is completely charged. q The battery indicator will not correctly display the remaining capacity for approximately 10 seconds after the power has been turned on. q When the AC adaptor or a separately available car adaptor is used, the battery indicator will not be shown. q The number of bars shown in the battery indicator may increase or decrease, depending on the operation being performed. This is normal.

Notes: q Setting the volume level to "0" whilst recording with the rechargeable or an alkaline battery reduces the battery drain. q When you do not use the unit for hours, remove the battery. (The battery drains gradually even when the power is turned off.) q Carry the battery in the supplied case.(MD-MT90H) q This unit can be used with the AC adaptor when the rechargeable or an alkaline battery is in the unit. Caution: Do not use a nickel-cadmium battery.

�8�