1. Fit the nozzle from the motor shaft side first, and rotate it into place on the dust container.
1. Press handle release pedal. Lay vacuum back on a flat surface. 2. Disconnect hoses from vacuum. 3. Rotate nozzle housing upward removing floor nozzle spring from dust compartment.
4. Once left side has cleared, remove nozzle housing from motor shaft.
2. Rotate nozzle shaft into groove on dust container. 3. Re-install the dust cover as outlined in the Dust Cover Removal and Replacement section. 4. Place floor nozzle spring into slot on dust compartment.
5. Reinstall dust cover as outlined in Dust Cover Removal and Replacement section.
3.7.
3.7.1.
Lower Plate Replacement
Removal
1. Place the Carpet/Bare Floor pedal in the carpet position and the handle in the upright position. 2. Turn the vacuum cleaner over exposing the underside. Release lower plate by pressing two (2) latches and two (2) locking tabs inward as shown.
3. Remove the lower plate and remove any residue that may exist in the belt area. 12
