3.12. Carbon Brush Replacement
3.12.1. Removal
1. Complete brush change on one side before starting on the other side. There are two (2) brushes located on the motor as identified. Remove the brush assembly by using a Phillips head screwdriver to remove the screw that holds the brush holder onto the motor.
NOTE: Do not drop screws into the motor.
3.12.2.
Replacement
1. Place new brush assembly on the motor.
2. Make sure that the amp terminal on the bottom of the brush assembly is inserted into the receptacle on the motor. 3. Replace the Phillips screw that was removed. 4. Repeat steps 1-3 for the other brush assembly.
