3-5 CD Mecha Continued
*When removing, take extreme care not to damage the hook. 1. Open the Tray Disc Ass�y by turning the Gear-Load(%) in the direction of open,then remove the Wire-Tray(Q). 2. Remove two Tray-Stopper and tray.
3-5-1 Tray Disassembly
1. Remove the Tray-Roulette(3) from the Tray-Disc Ass�y(4) by releasing the hook. 2. Remove the PCB-Sensor Ass�y(5) from the tray by releasing the hook. 3. Remove the Worm-Motor Ass�y())from the Tray-Disc Ass�y(4). 4. Remove the Cushion-Motor(1) from the Tray. 5. Remove the Gear-Roulette(2) from the Tray-Disc Ass�y(4) by releasing the hook.
3-5-2 Main Disassembly
1. Remove the Table-Chuck Ass�y(6) from the Base-Main by turning it. 2. Push the Slider-Cam(!)towards right, then lift it up to remove. 3. Remove the Gear-Tray(^) from the Base-Main by releasing the fixed hook. 4. Remove the Gear-Converter(&)from the Base-Main by releasing the fixed hook. 5. Remove the Gear-Cam(%) from the Base-Main by releasing the fixed hook. 6. Remove the Belt(@) from the Pulley-Motor Ass�y(7) & the Gear-Pulley(#). 7. Remove the Gear-Pulley(#) from the Base-Main by releasing the fixed hook. 8. Remove the Gear-Load($). 9. Remove the Gear-Synchro(*). 10. Desolder two soldering points of the CD SUB PCB, then remove it from Base-Main by releasing the hook. 11. Remove the Pulley-Motor Ass�y(7) by releasing the hook. 12. Remove the PCB-SW Ass�y(8) by releasing the hook.
3-5-3 CD Main PCB Disassembly
1. Remove the Lever-Lifter(9) from the Base-Main by releasing two hooks. 2. Remove four Rubber-CD(0) from the Lever-Lifter and then remove the Deck-CD(�). 3. Remove the Hook. 4. Remove the CD MAIN PCB with the soldering iron.
