SAMSUNG MAX630
Manual de Servicio

4-3 CD
4-3-2 To Adjust Tracking Gain (PLAY mode)
1. Connect the GND terminal of the oscilloscope to VR and (+) terminal to TP2. 2. Load and play the disc 3. While the disc is running adjust the gain with NVR1704 as shown below. Normal frequency Low frequency High frequency

---0 V

---0 V

---0 V

TE CENTER FE CENTER E.F BAL F.BIAS

VOLT/DIV : 0.2V TIME/DIV : 2mS

VOLT/DIV : 0.2V TIME/DIV : 2mS

VOLT/DIV : 0.2V TIME/DIV : 2mS

NVR1704 NVR1703 NVR1702

NVR1701

4-3-3 To Adjust Focus Gain (PLAY mode)
1. Connect the GND terminal of the oscilloscope to VR and (+) terminal to TP1. 2. Load and play the disc. 3. While the disc is running adjust the gain with NVR1703 as shown in the following figure. Normal frequency Low frequency High frequency

Vref

---250mV ---100mV ---0 V ---100mV ---0V ---0 V

TP1 TP2

VOLT/DIV : 0.1V TIME/DIV : 2mS

VOLT/DIV : 0.1V TIME/DIV : 2mS

VOLT/DIV : 0.1V TIME/DIV : 2mS

4-3-4 To Adjust E/F Balance (PLAY mode)
1. Set TIME/DIV of the oscilloscope to 2mS. 2. Set Volt/DIV of the oscilloscope to 0.5V. 3. Ground the scope input and set to DC. and then set the DC range. 4. Connect the GND terminal of the oscilloscope to VR and (+) terminal to center to TP2. 5. Load and play the disc. 6. Turn NVR1704 counterclockwise to the minimum value. 7. Raise NVR1702 and adjust the waveform so that its middle comes to GND of the oscilloscope (or until the upper half of waveform becomes symmetrical to the bottom half, A=B) 8. Adjust NVR1704 (arrow) for normal sound.

4-3-1 To Adjust FOCUS BIAS(STOP mode)
1. Set Volt/Div of the oscilloscope to DC 100mV. 2. Ground the scope input and set the waveform to 0V, DC range. 3. Connect the GND terminal of the oscilloscope to VR, and (+) terminal to center of TP1. 4. Set NVR1701 to 0mV.

0V A

B A=B

4-4

Samsung Electronics