SHURE LXWIRELESSSYSTEM
Manual del propietario

LX Wireless
WH20 HEADSET WM98 MIC & A98KCS HORN MOUNT

WA302 INSTRUMENT ADAPTER CABLE

RECEIVER

LX1 BODY�PACK SYSTEM SETUP AND OPERATION FIGURE 14

OPERATING LX1 BODY�PACK SYSTEMS (FIGURE 14)
1. Clip the LX1 body pack transmitter to your belt, waistband, or guitar strap. 2. Connect the lavalier microphone, headset or instrument adapter cable to the body� pack transmitter. 3. If you are using a lavalier microphone, clip the mic to your tie, lapel, or other garment. If you are using a headset, put the headset on. If you are using a Shure WM98 microphone, insert it into an A98KCS horn mount and clamp it to your horn. If you are using an instrument adapter cable, plug the cable into the instrument. 4. Slide the transmitter PWR/OFF switch to the PWR position. One of the three lights on the transmitter will glow. 5. Press the POWER button on the receiver. The green �power on� light on the receiver and the RF light(s) will glow. 6. Slide the transmitter ON/MUTE switch to the ON position and begin speaking or playing your instrument. NOTE: If the red PEAK light on the receiver does not flicker during the loudest sounds, the transmitter gain may need to be increased. Refer to the Adjusting the Transmitter Audio Gain Level section. Then, if the system is still not operating properly, consult the Troubleshooting table. 7. During the performance or presentation, slide the ON/MUTE switch to the MUTE position when the system is not being used. 8. When the performance or presentation is over, slide the transmitter PWR/OFF switch to the OFF position to conserve battery power. 16

�

�

LAVALIER MIC