TEAC LT-1
Manual de Servicio

LT-1/LT-1B
3 ADJUSTMENTS AND CHECKS
3-1 TUNER SECTION
Use a screwdriver with a plastic or ceramic grip for all adjustment.

3-1-1 AM adjustment
1. Set the function switch to the TUNER position. 2. Set the BAND switch to the AM position. 2. Connect the test loop antenna across the output of the signal generator. 3. Connect the oscilloscope to the PHONE JACK terminal. 4. Set the signal generator as listed in the alignment chart.

3-1-2 FM adjustment
1. Set the function switch to the TUNER position. 2. Set the BAND switch to the FM position. 3. Connect the signal generator output through a 75 ohm dummy antenna to "ANT" on TUNER PCB.CN8. 3. Connect the oscilloscope to the PHONE JACK terminal. 4. Set the signal generator as listed in the alignment chart.

3-2 Adjustment and Test Points

LT-1 TUNER PCB

L3
TC1

AM ANT COIL

L5

L4

CN8

TUNER

Fig. 3-2-1

4