WHIRLPOOL LSG2704W
Manual de Usuario

OPERATING

THE DRYER CONTROLS
approximately 5 minutes momentary buzzer. of cool down and a

I

,i

_H_

WRINKLE RELEASE -- Found in the Time Dry portion of the dial, use this cycle to release wrinkles from items that are clean and dry but slightly wrinkled from a crowded closet or suitcase or from sitting in the dryer after the cycle is complete. It provides 10 minutes of heated tumbling and 5 minutes of cool down. DAMP DRY -- To partially dry items to a damp state, select "damp dry" on the Time Dry portion of the controls. The clothes will tumble in heated air for 20 minutes, then cool air for 5 minutes. AIR FLUFF -- Turn the cycle selector dial to the AIR FLUFF portion for the desired number of minutes. This provides tumbling without heat.

1. SELECT

DRYING

TEMPERATURE

Turn the temperature selector knob to the proper drying temperature. The choices are: REGULAR -- Use this setting for drying sturdy cottons or regular garments and those items labeled "Tumble Dry," etc. DELICATEUse this setting for drying those heatsensitive items labeled "Tumble Dry Low," "Tumble Dry Warm," etc.

3. PUSH THE BUTTON TO START
This dryer is designed so that it when the door is open. If the door the cycle is complete, the door must start button pushed again to restart will not operate is opened before be closed and the the dryer.

2. SELECT THE CYCLE
The Electronic Dry Control cycles include Regular Fabrics and Permanent Press. These cycles provide automatic sensing of the moisture amount in the load and shut off when the selected dryness is reached. The time required to reach that dryness will vary for each load according to the size of the load, the weight of the fabric, length of venting, etc. For these cycles, turn the cycle control to the desired start position. The Time Dry cycle does not sense the moisture, but rather, dries items by setting a desired time on the controls, REGULAR FABRICS -- Use this cycle for non-permanent press loads such as towels, underwear, etc. At the end of the cycle there is an automatic cool down of approximately 7 minutes and a momentary buzzer. PERMANENT PRESS -- Use this cycle for permanent press loads or no-iron fabrics such as nylon, acrylic, polyester or blends. At the end of the cycle there is an automatic cool down of approximately 30 minutes to minimize wrinkling. The buzzer will sound once or twice during the cool down to let you know the cycle is nearly over and again when the dryer turns off. TIME DRY -- This cycle may be used for any load when Electronic Dry is not preferred. Set the dial to the amount of time desired. This will be followed by

4. REMOVE LOAD IMMEDIATELY
At the completion of any cycle, a buzzer will sound momentarily to let you know the dryer has shut off. On the Permanent Press cycle, the buzzer will sound after the normal cool-down period to let you know Press Care tumbling has begun and the load can be removed at any time. 5. DRYER ENERGY SAVING TIPS effi-

� Clean the lint filter after each cycle for greater ciency and performance.

� Avoid overloading the dryer. Aproper wash load is a proper dryer load. Do not combine loads. Avoid drying very small loads or mixed loads of heavy, hard-to-dry items with lightweight ones. � Properly select and check exhaust venting. Four inch rigid metal ducting is recommended to prevent lint collection and improve dryer operation. Periodically check the ductwork for any obstructions that could reduce the airflow and efficiency. � Remove items from the dryer as soon as tumbling stops for best results and efficiency. This reduces wrinkling and ironing.

7