SHARP LL-T15V1
Manual de Servicio

PC-UM10M

s Adjusting the screen automatically
1. Press the MENU button. The ADJUSTMENT Menu will be displayed.
ADJUS TMEN T MANU AL CL OCK P HA S E H-P OS V-P O S 127 16 2 00 29 AU TO

MENU 1: ADJUSTMENT

ADJUS TMENT MANUAL CL OCK P HAS E H-P OS V-POS 11 6 27 200 29 AUT O

1024X768 V :75Hz H :60.0kHz

1024X768 V :75Hz H :60.0kHz

MANUAL : Individual menu options are manually adjusted. 2. Press the d button. The screen will become dark and [ADJUSTING] will be displayed. After a few seconds the ADJUSTMENT Menu will return. (The automatic adjustment is now complete.) 3. Press the MENU button 4 times to make the On Screen Display (OSD) Menu disappear. Notes: � In most cases automatic adjustment is sufficient. � If necessary due to any of the following, manual adjustments can be performed after the automatic adjustment. � When further fine adjustment is needed. � When the computers video input signals are Composite Sync or Sync On Green. � (Automatic adjustments may not be possible.) � When [OUT OF ADJUST] is displayed. (When the screen displays an entirely dark image, the automatic screen adjustment may be disabled. When making an automatic adjustment, be sure to either use the Adjustment Pattern or try displaying an image that makes the entire screen very bright.) � One execution of the automatic adjustment may not realize the proper adjustment result. In that case, repeat the automatic adjustment a few times.
Vertical flicker noise

AUTO

: Every menu option is automatically adjusted.

Notes: � Press the d button to select [AUTO]. � To choose a menu option: SELECT button � To go to the next menu: MENU button CLOCK The figure below demonstrates how to adjust so that vertical flicker noise is not emitted. (e d buttons)

PHASE The figure below demonstrates how to adjust so that horizontal flicker noise is not emitted. (e d buttons) Note: Adjustments to PHASE should be made only after CLOCK has been correctly set.

4-3. MANUAL SCREEN ADJUSTMENT
Adjustments can be made using On Screen Display (OSD) Menu provided. 1. Display an image that makes the entire screen very bright. If using Windows, you can open and use the Adjustment Pattern on the accompanying Utility Disk. 2. Press the MENU button. The ADJUSTMENT Menu will be displayed.
A DJUS TMEN T MANU A L C L OC K PH A S E H-P OS V-PO S 1 27 16 200 29 AU TO

Horizontal flicker noise

H-POS (horizontal positioning) and V-POS (vertical positioning) To center the screen image within the boundaries of the screen, adjust the left-right (H-POS) values and the up-down (V-POS) values. (e d buttons)
Screen frame

1024X768 V :75Hz H :60.0kHz

At this point relevant menu options can be adjusted. Each time the MENU button is pressed the next menu is selected. (ADJUSTMENT 3 GAIN CONTROL 3 WHITE BALANCE 3 MODE SELECT 3 OSD Menu disappears) Notes: � The OSD Menu automatically disappears approximately 30 seconds after the last command. � This explanation is based on using the Adjustment Pattern (for Windows) to make adjustments.
LL-T15V1 CONNECTION, ADJUSTMENT, OPERATION AND FUNCTIONS

2�5