Drain as much water as you can from the hoses through the faucet connector
l
Using your Washer
Hang the hoses back onto therr storage rack, as shown below
l
As a Portable, Connections:
Two Faucet
Your washer IS easy to use. To It even easrer, read the following
If you have the two separate water Inlet hoses and the drain hose, your washer can be connected to both hot and cold water faucets.
make
Connecting
l
the Washer:
Connect hot and cold water inlet hoses to hot and cold faucets. l Secure dram hose to sink or standpipe l Plug power supply cord Into a grounded outlet.
steps before starting your first load. Start your washer after you put in detergent. any other laundry aids (see page 3). and the load
1.
l
Set the WATER LEVEL Selector.
Select the water level that matches the srze of the load. See page 7 for more information l You can change thus setting at any time while the washer is filling.
IMPORTANT: For the best cleaning results with the least wrinkling Disconnecting
l
the Washer:
water 2.
for items to move
freely.
Turn water faucets off. l Unplug power supply cord and return it to Its storage area. l Disconnect and drain water supply hoses Hang them on the storage rack.
AdJust the Water Temperature.
If your washer has the hose conset the water the water at or cold
nection for a single faucet, temperatures by adjusting the faucet position.
l
..to the hot, warm
Permanent
Installation:
Thus washer can be converted from portable to permanent. InstructIons for permanent ~nstallatron come wrth the washer. Two fill hoses, one dram hose and four levelllng legs needed can be purchased from your Whirlpool Dealer
Set the WATER TEMP Dial to WARM COLD or COLD/COLD. Adjust the faucet so water is as hot as you want for the wash l Rinse Water Temperature. After the washer fills and begins agitating the load, adjust the faucet to the rinse temperature you want (cold IS recommended). 0 Be sure to use cold rinse water for the PERMANENT PRESS Cycle.
Wash Water Temperature.
Or Set the WATER TEMP Selector
If your washer has two inlet hoses and a drain hose, or IS permanently installed, turn the WATER TEMP Dial to a washi rinse water temperature combination. l Match the water temperatures to the type of fabrics and soils to be washed
l
