PHILIPS LC4031G
Manual de Usuario

6. SET UP

INSERTING THE BATTERIES IN THE REMOTE CONTROL Horizontal angle (horizon) � Adjust or correct a possible oblique displayed picture by turning the horizontal adjusters to the desired position.

Push

On/Off f

Standby Lamp Mute RC RC

Data ta
Video

AVMute
Menu
OK

Volume

Video
S-Video in Video in L Audio R

Data
Mouse Data in in

Audio

Power

out Audio in

1. Push and slide the lid in the direction of the arrow. 2. Install three �AA� batteries as indicated inside the battery compartment. 3. Replace the lid and snap into place. Caution: Do not mix old and new batteries (also never mix alkaline and manganese batteries).
Note: The maximum range of the remote control is 20 m (± 65 feet).

Up: turn the adjuster(s) to the left. Down: turn the adjuster(s) to the right. � Use the FOCUS Ring and ZOOM Ring to readjust the focus and size of the image.

Notes: � When adjustments are not properly made, the picture may become distorted, depending on the relative positions of the projector and the screen. � If the projector and the screen are not properly placed, the picture will be distorted, producing a keystone image as shown at right. Keystoned Image

CAUTION! When all required adjustments have been made, switch off the projector before making any other connections (see �Installation�).
MOVING THE PROJECTOR

1. Press the STANDBY/ON/OFF button to switch off the projector. The standby indicator lights up red. 2. Wait until the cooling fan has stopped (about 3 minutes after the projector has been switched off) and disconnect the mains lead and all other cables. 3. Make sure the lens is turned back in to prevent damage to the lens. 4. Put the lens cap back in place to prevent dust, dirt or other contamination from harming or damaging the front of the projector lens when moving the projector.

On/Off

Standby Lamp Mute RC RC

Data ta
Video

AVMute te
Menu
OK

Volume

Video
S-Video in Video in L Audio R

Data
Mouse Data in in

Audio

Power

in Audio out

Note: Never place the projector on the side where the connections are located.
9

English