WHIRLPOOL LAT5005ABW
Manual de Usuario

Select

Cycle

and Time

Start

the

Washer

Push in the eyele control knob and turn cloekwise to the proper cycle and wash time. For REGULAR FABRICS, turn the control knob to 12 minutes for heavily soiled loads; to 6-i0 minutes for normally soiled loads; and to less than 6 minutes for lightly soiled loads. For PERMANENT PRESS loads, turn the control

Pull out the cycle control knob to start the washer. You will hear water entering the wash tub. The washer will fill to the selected water level _ith the selected wash water temperature. After filling, it will agitate for the selected number of minutes. The washer will pause briefly throughout cycle. These pauses are normal. each

knob up to 10 minutes for hea_ly soiled loads; to 6-8 minutes for normally soiled loads; and to less than 6 minutes for lightly soiled. Due to the extra coo] down rinse which minimizes wrinkling, this cycle can also be used for non-permanent press items when additional rinsing is needed. To SOAK heavily soiled or stained items on the l_cgular or Permanent Press cycle, push in the eontrol knob after the washer has agitated a few minutes. This _11 stop the washer and let the load soak. Generally, soak periods up to 30 minutes are sufficient for most loads (overnight soaking is not necessary or reeommended). Up to 50% more detergent is reeommended or use of a presoak product such as Biz* when a soak period is used. To start washing again, pull out the control knob, the washer will resume the eyele at the point of interruption.
°Brand names are the trademark of the respective manufacturers.

This washer is designed so that it will not agitate or spin when the lid is open. It will, however, fill with the lid open so water is available for pretreating stains or diluting fabric softener. Should the lid be opened during a cycle, the washer will stop; when the lid is dosed and the control knob is pulled out, the washer will resume its cycle at the point it was interrupted, NOTEi If the -washer stops during the spin, it may be clue to an unevenly distributed load. If this happens, push in the control knob, open the lid, redistribute the load, close the lid and pull out the control knob.

PAGE 5