WHIRLPOOL LA6400XKW0
Manual de Usuario

Liquid Fabric Softener Dispenser
The dispenser for llquld fabric softener fits over the, top of the agitator The dispenser WIII k 31d enough diluted fabric softener for one deep rinse l After adding the jetergeni and the load, fii the dlspen;er over the top of the agitator cap

l �he washer WII! fill, agitcte fo7 �AC minutes, soak for eight mlrJtes 7Jl+ate

for two more, and trien drai? cr�j spir [See SOAK CYCLE descrlD+ior3� unge 10 )
l

After filling, the washer may before starting to agitate.

pause

For Rinsing Only
Your washer can be set to rinse only Use the setting for an extra rinse or for laundry that only needs a rirse ard spin

PERMANENT PRESS

Full Mark
FolIowIng directions on the bottle, add the correct arr>ouni of fabric softener Use a cup with a pouring spout to avold dripping any on the load
l

IMPOf?TANT: Add enough hot or warm water to fill the dispenser to the FULL mark.
Diluted fabric softener ~111be added just before the washer starts filling for the rinse. NOTE: Do not stop the washer during the first spin (when the wash water IS spinning out] If you do, the fabrlc softener WIII be added to the wet, soapy load This can cause stains l Clean the dispenser after each use with warm wafer only. Detergent can make softeners sticky and lumpy.
l

l

There is a doi just after the numbers in PERMANENT PRESS, REGULAR HEAVY and KNITS GENTLE If YOU push lr on the Cycle Control Knob, turn the pointer to one of those dots and pull the Control Knob out, the washer iz/lli fill, agitate, drain and spin. If you want high agitation and spin. use the dot In REGULAR HEAVY If you want low agitation and spin, use ihe dot in KNITS GENTLE Use the dot in PERMANENT PRESS if you want high agltatlon and a low-speed spin

For Spinning

Only

For a Pre Wash
Use this setting for a shorter SOAK CYCLE (no rinse). Use enough detergent for a single wash. Add the load l Set the LOAD SIZE SELECTOR. l Set wash water temperature. l Push the Cycle Control Knob in and turn it to the 12-minute mark in the SOAK CYCLE

To set the washer so it drains and spins water out of the load, push in or� the Control Knob, turn the dial to the right (clockwlse) so the pointer IS touchy ing the bar just before OFF in any cycle

REGULAR

l

Pull the Control washer

Knob

out to start ihe

The washer will drain, spin out water and stop If you want a low-spee spin, use the bar on PERMANENT PRESS or KNITS GENTLE, All the other cycle settings have a high-speed spin.