AEG L66600
Manual de Usuario

3

Special spanner A and sealing caps B (2 units) and C (1 unit) come with the appliance. 3. Use special spanner A to remove screw D and the compression spring. 4. Use sealing cap C to cap the hole. 5. Use special spanner A to remove the two screws E. 6. Use special spanner A to remove the four screws F. 7. Remove transit bar G. 8. Screw in the four screws F again. 9. Use sealing caps B to cap the two large holes. Important: Press all sealing caps B (2 items) and C (1 item) in firmly so that they snap into the rear wall.

Where to install
Important! The washing machine must not be operated in a room where there is a danger of frost. There is a risk of frost damage or adverse effect on the perfomance of the machine. Frost damage is not covered under the warranty. � The surface on which the appliance is to be installed must be firm and level. Do not install the appliance on carpeted floors or soft floor coverings. � The surface on which the appliance is to be installed must be clean and dry and free from grease, so that the appliance does not slide. � If the location in which the appliance is to be installed is fitted with small-format tiles, put a rubber mat (available in the shops) under the appliance. If the appliance is to stand on a floor which moves, e.g. a suspended wooden floor: Place the appliance in an area as close as possible to a corner of the room. Screw a water-resistant wooden board (at least 15 mm thick) onto at least 2 of the floor joists.

28