SONY KVPG21M10
Manual de Servicio

2-7. PICTURE TUBE REMOVAL Note:
� Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom right and left.

� REMOVAL OF ANODE-CAP
NOTE : � The picture tube is upside down, and the position for the anode cap and tension springs are changed accordingly. � Please remove necessary CRT support located on top left, top right, bottom left, bottom right, prior to removing the CRT.

!� Cushion (50x550) DGC 8 Demagnetic coil !¡ Holder DGC

� REMOVING PROCEDURES

a

!£ Cushion (35x250) DGC
a

7 Chassis assy 4 Four screws (washer head) (BVTP 3 � 12) 2 CV board 5 Deflection yoke 6 Tension spring 9 Two screws (Tapping 5 + Crown Washer)

1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
A Board
b b

11 �
3 Speaker (5 � 9cm) !º Two screws (Tapping 5+ Crown Washer)

2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
c

1 Anode cap
Anode Button

Coating earth assy Screw Location

3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c. 1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.

�

HOW TO HANDLE AN ANODE-CAP

CRT Support Block !� Picture tube !¢ Cushion

CRT Support Block

Slim Beznet

KV-PG21M10

RM-952