SONY KV29FX60U
Manual de Servicio

First Time Operation
The following chapter contains all the steps necessary when first installing your TV and the basic TV functions.

Step 2 Basic Presetting
A The Menu System
Your TV uses an on-screen menu system to guide you through the operations. Use the following buttons on the Remote Control to operate the menu system:

Step 1 Installation
A Connecting the TV Set
1 2a 2b Connect the TV set to the mains socket (220-240 V. AC, 50 Hz). Connect a conventional aerial cable to the socket marked � M on the rear of the TV set. or Connect your Satellite Receiver to one of the Scart connectors J K L of the TV set. When connecting a VCR to your TV set: We recommend that you use the preset function Manual Programme Preset (page 33) to tune in the VCR signal to programme position 0.

� � � �

Press MENU !� to switch the menu on and off. Use �, �, 4, $ of the joystick !¡ to select within the menu system. Press OK to store. When menu is switched off: Press � to return to the last menu screen.
Language/Country Language Country

English Off

Select:

Enter:

VIDEO
OUT IN

B Selecting Language and Country
SAT

R/D/D/D

L/G/S/I

R/D/D/D

L/G/S/I

1 2

Press the MENU !� button. The menu Language/Country appears on the screen. Push the joystick !¡ to �. Push the joystick !¡ to $ to select the language. Press OK !¡. The menus appear in the selected language.

Language/Country Language Country English Off

10
B Inserting the Batteries into the Remote Control
Make sure to insert the batteries using the correct polarities. Dispose of exhausted batteries according to your local regulations. 3 4

Push the joystick !¡ to $ to select Country. Push the joystick !¡ to �. Select the country in which you will operate the TV set using $ or 4. Confirm by pressing OK !¡. The menu Auto Tuning appears.

Select:

Enter:

Language/Country Language Country
Off Austria Belgium Bulgaria Czech Rep. Denmark Finland

English

Select Country:

Confirm: OK

C Automatic Tuning In of Channels C Switching on the TV Set
�
Press the switch U E at the front of the TV set. If the standby mode indicator u D on the TV is lit, press TV I/u 1 on the Remote Control to switch on the TV set.
� �

�

Push the joystick !¡ to �. After all available channels are stored, the TV goes back to the programme position with which you started the automatic tuning. Your TV is now ready for use. To stop the automatic tuning: Press OK !¡.

Set Up

Auto Tuning Start Programme Sorting AV Preset Installation

Select:

Start Auto Tuning:

If you wish to change the sequence of the stored channels, go to Sorting Programme Positions in Advanced Presetting. If you need to change or repeat the tuning afterwards (e.g. when you move house) : select the menu Auto Tuning in the Set Up menu.
1 2 3 4 5 CO2 CO3 CO4 CO7 CO8

�

D

E

Searching

30

First Time Operation

First Time Operation

31