SONY KV28WF1D
Manual de Servicio

KV-28WF1

SYSTEM B/G, D/K, I & L I.F ADJUSTMENT

DEFLECTION SYSTEM ADJUSTMENT

1. Input an off air signal of between 60-100dBuV / 75 ohm terminated, via the tuner socket. 2. Enter into the I.F adjustment service mode (i.e. " TT 59 " ) to fix the I.F frequency to 38.9 MHz. 3. Enter into the service mode and select "Current TVStatus". 4. Adjust the I.F coil (LV01) until the "AFT Status" indicates a " Window " condition.
SYSTEM L BAND 1 I.F ADJUSTMENT

1. Enter into the Geometry Adjustment Service Menu. 2. Select and adjust each item in order to obtain the optimum image.

GEOMETRY ADJUSTMENT V Size V Position S Correction V Linearity H Size H Position Pin Amp Pin Phase AFC Bow AFC Angle EHT V EHT H Corner Pin Adj Adj Adj Adj Adj Adj Adj Adj Adj Adj Adj Adj Adj

1. Input an off air signal of between 60-100dBuV / 75 ohm terminated, via the tuner socket. 2. Enter into the I.F adjustment service mode (i.e. " TT 59 " ) to fix the I.F frequency to 34.2 MHz. 3. Enter into the service mode and select "Current TVStatus". 4. Adjust the RV02 until the "AFT Status" indicates a " Window " condition.
TUNER AGC ADJUSTMENT

1. Receive a signal of 63dBuV / 75 ohm terminated via the tuner socket. 2. Measure the voltage at test point 1 (A board). 3. Adjust RV01 to obtain a voltage of 3.0V ± 0.3V.

V SIZE

RV01 RV02 LV01

V LIN

S CORRECTION

A
TUNER / IF

TP1

V CENTRE

H SHIFT

H SIZE

- A Board component side -

PIN AMP

TILT

CORNER PIN

V ANGLE

� 30 �