SONY KV25K1K
Manual de Servicio

KV-25K1

2-5. A BOARD REMOVAL
Push the claw of the bracket in the direction of the arrow and remove.

2-6. PICTURE TUBE REMOVAL
7 Holder DGC

8 Degaussing coil 9 Spring tension

C board 10 Speaker 4 Two Screws 3

6 Chassis 11 Neck Assy
Four tapping screws (M) 13

18 �

12 Deflection
Yoke

�

REMOVAL OF ANODE-CAP
carbon paint on the CRT, after removing the anode.
* REMOVING PROCEDURES.

Note: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or

2 Speaker

Anode cap 5
c
a
b b

1

Turn up one side of the rubber cap in the direction indicated by the arrow a

2

Using a thumb pull up the rubber cap 3 firmly in the direction indicated by the arrow b

�
1 2
3

HOW TO HANDLE AN ANODE-CAP Don't damage the surface of anode-cap with sharp shaped material ! Don't press the rubber hardly not to hurt inside of anode-caps ! A metal fitting called as shatter-hook terminal is built into the rubber. Don�t turn the foot of rubber over hardly ! The shatter-hook terminal will stick out or damage the rubber.

When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c

Anode button

Picture tube 14

1 Two Screws

Cushion