KENWOOD KRFV7060D
Manual de Usuario

Setting up the system

Connecting the terminals
1 Strip coating. 2 Loosen.

Speaker placement
Center speaker

3 Insert.

4 Secure.

Subwoofer Front speakers (L,R) Surround speakers (L,R)
1 Strip coating. 2 Push the lever.

Listening position

Surround back speaker

3 Insert the cord.

4 Return the lever.

Front speakers : Place at the front left and right of the listening position. Front speakers are required for all surround modes. Center speaker : Place front and center. This speaker stabilizes the sound image and helps recreate sound motion. Required for surround playback. Surround speakers : Place at the direct left and right, or slightly behind, the listening position at even heights, approximately 1 meter above the ears of the listeners. These speakers recreate sound motion and atmosphere. Required for surround playback. Subwoofer : Reproduces powerful deep bass sounds. Surround back speaker : Place the speaker directly at the rear of the listening position. The optimum position depends mainly on the room condition.

Connection of banana plugs (For the U.S.A. and Canada)
1 Secure. 2 Insert.

� Although the ideal surround system consists of all the speakers listed above, if you don't have a center speaker or a subwoofer, you can divide those signals between the available speakers in the speaker settings steps to obtain the best possible surround reproduction from the speakers you have available. *

� Sound will not be heard if the speaker terminal is not fully secured. � Never short circuit the + and � speaker cords. � If the left and right speakers are connected inversely or the speaker cords are connected with reversed polarity, the sound will be unnatural with ambiguous acoustic imaging. Be sure to connect the speakers correctly.

Channel space switching
(Except for the U.S.A., Canada, U.K., and Australia)
The space between radio channels has been set to the one that prevails in the area to which the system is shipped. However, if the current channel space setting does not match the setting in the area where the system is to be used, for instance when you move from area 1 or area 2 shown in the following table or vice versa, proper reception of AM/FM broadcasts cannot be expected. In this case, change the channel space setting in accordance with your area by referring to the following table. Area 1 2 U.S.A., Canada and South American countries Other countries CHANNEL Space Frequency FM: 100 kHz AM: 10 kHz FM: 50 kHz AM: 9 kHz

Speaker impedance
After confirming the speaker impedance indications printed on the rear panel of the receiver, connect speakers with matching impedance ratings. Using speakers with a rated impedance other than that indicated on the rear panel of the receiver could result in malfunctions or damage to the speakers or receiver.

75us AM 10kHz FM100kHz

50us AM 9kHz FM50kHz

75us AM 10kHz FM100kHz

50us AM 9kHz FM50kHz

DE-EMPHASIS CHANNEL SPACE

DE-EMPHASIS CHANNEL SPACE

Turn the power OFF by pressing the POWER key before moving the switch level. Move switch lever to match your area with a small screwdriver or other pointed tool, then turn the power on again.

15 EN