DISASSEMBLY FOR REPAIR
How to install the Volume Knob
1. Remove the peeling paper of LIGHTING BOARD BOSS side. 2. CAP and LIGHTING BOARD are install positioning as shown.
LIGHTING BOARD
How to remove the Volume Knob
1. Remove the rear cover of panel unit. 2. Juck up as remove the switch unit (x16-) and Volume Knob as shown.
Be careful of direction.
CAP
3. Remove the peeling paper.(Use Tweezers) 4. CAP and Volume Knob are install positioning as shown.
(CAUTION)
Volume Knob cannot pull of front side that looked at tab point in the rotary encoder.
Rib: short Rib: tall
CAP
KNOB(VOL)
Dented part
5. Install a Volume Knob in rotary encoder positioning as shown.
KNOB(VOL)
Mount the Volume Knob into the broad Y shaped cutting in the direction of the picture.
