SONY KP-57WV600
Manual de Usuario

General
Problem Possible Remedies

How to reset TV to factory settings

�

How to restore Video settings � to factory settings How to restore Audio � settings to factory settings Cannot cycle through the � other video equipment connected to the TV Cannot operate Menu � Lost password �

Turn on the TV. While holding down the RESET button on the remote control, press the POWER button on the TV. (The TV will turn itself off, then back on again.) Release the RESET button. Press the RESET button on the remote control while in the Video Menu (see page 72). Press the RESET button on the remote control while in the Audio Menu (see page 74). Be sure the Video Label option is not set to Skip (see page 84).

LED on front panel is lit

� �

If a menu option appears in gray, this indicates that the TV is in a state in which the menu option is not available. In the password screen (see page 80), enter the following master password: 4357. The master password clears your previous password; it cannot be used to temporarily unblock channels. The STAND BY LED (see page 14) blinks when the TV is turned on, then shuts off when the picture is displayed. If the LED blinks continuously, this may indicate the TV needs service. The TIMER LED (see page 14) indicates that the timer is set. When the timer is set, this LED will remain lit even when the TV is turned off.

Other Info SETUP Welcome

94