|
Usuarios conectados
Actualmente hay 4419 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
INSTALLATION
1. Steady, flat location.
This microwave oven should be set on a steady, flat surface.
2. Leave space behind and side.
All air vents should be kept a clearance. If all vents are covered during operation, the oven may be overheated and, eventually, oven failure caused.
3. Away from radio, and TV sets
Poor television reception and radio interference may be resulted in, if the oven is located close to a TV, Radio, or antenna, feeder and so on.
4. Away from heating appliances and water taps
Keep the oven away from hot air, steam or splash when choosing a place to position it, or the insulation might be adversely affected and breakdowns occur.
5. power supply
� Check your local power source. This microwave oven requires a current of approximately 5 amperes, 230V 50Hz. use a receptacle that will accept the earth prong. � Voltage Warning The voltage used must be the same as specified on this Microwave Oven. Using a higher voltage may result in a fire or other accident causing oven damage. Using low voltage will cause slow cooking. We are not responsible for damage resulted from use of this Microwave Oven with a voltage or amperage fruse other than those specified. � Power supply cord is about 1.0 meters long. Do not use an extension cord. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard; CAUTION : Do not be under any circumstances cut or remove the round earthing prong from this plug. CAUTION : Maintenance work like the replacing the power cable must be made by a qualified technician of the after-sales-services. WARNING: This appliance must be earthed.
IMPORTANT
The wires in this main lead coloured in accordance with the following code. Green-and-yellow : Earth Blue : Neutral Brown : Live As the colours of the wires in the main lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the letter �E� or by the earth symbol or green-and-yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter �N� or coloured white. The wire which is coloured brown must be connected to the terminal which is marked with the letter �L� or coloured red.
6. Examine the oven after unpacking for any damage such as:
Dents, A misaligned door, Broken door, Dents in cavity. If any of the above are visible, do not install this oven.
6
|
|
|
> |
|