KENWOOD KMD-671R
Manual de Usuario

English

Installation s Removing the hard rubber frame 1 Engage the catch pins on the removal tool and remove the
two locks on the lower level. Lower the frame and pull it forward as shown in the figure.

s Removing the Unit 1 Refer to the section �Removing the hard rubber frame� and
then remove the hard rubber frame. 2 Remove the screw (M4�8) on the back panel.

3 Insert the two removal tools deeply into the slots on each
Lock Catch

side, as shown.

Screw (M4X8) (commercially available) Accessory2 Removal tool

Catch facing up

2 When the lower level is removed, remove the upper two
locations.
Accessory2 Removal tool

4 Lower the removal tool
toward the bottom, and pull out the unit halfway whilst pressing towards the inside.

2CAUTION

Be careful to avoid injury from the catch pins on the removal tool.
NOTE

The frame can be removed from the top side in the same manner.

5 Pull the unit all the way out
with your hands, being careful not to drop it.

� 30 �