CASIO KL430
Manual de Servicio

9. MESSAGES
Problem ERR! message appears for one second. Possible Cause � Attempt to input two the same text. marks within Action � Use only one mark. Only two lines of text can be input, so text can contain only one mark. � Do not use marks. 6 mm tape can have only one line of text, so text cannot contain any marks. � Delete the mark to print on 6 mm tape or switch back to a wider tape.

� Attempt to input mark while 6 mm is specified as the tape width.

� Label text containing a mark was input and then tape width specification was changed to 6 mm. (ERR! message appears when you try to perform a print operation.) � Text that is longer than 5.5 cm when stamp printing is selected. � Attempt to print a stamp while 6 mm is specified for the tape width. FUL! message on the display. BATT message on the display. ERR! message on the display. � Both text memory areas (AREA 1 and AREA 2) already contain text. � Battery power is too low. � Memory data has become corrupted for some reason. Table-4

� Shorten the text to be printed and try again. � Change the tape width setting to OFF and try printing the stamp again. � Delete text from one of the text memory areas and then store the new text. � Replace batteries. � Initialize the Label Printer.

� 10 �