PIONEER KEH-P7035/XN/ES
Manual de Usuario

HHHHHHHHHHHHHH Audio Adjustments

Section

07

3 Press c or d to select the phase of subwoofer output. Press c to select reverse phase and Rev. appears in the display. Press d to select normal phase and Normal appears in the display.

# When the subwoofer controller setting is only S.W Control:EXT, you can switch to the non fading output on/off setting. (Refer to page 31.)

Adjusting subwoofer settings
When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. 1 Press AUDIO to select Sub-W2. Press AUDIO until Sub-W2 appears in the display.
# When the subwoofer output is on, you can select Sub-W2.

2 Press a to turn non fading output on. NonFad ON appears in the display. Non fading output is now on.
# To turn non fading output off, press b.

Adjusting non fading output level
When the non fading output is on, you can adjust the level of non fading output. 1 Press AUDIO to select non fading output setting. Press AUDIO until NonFad 0 appears in the display. 2 Press a or b to adjust the output level of the non fading. Each press of a or b increases or decreases the level of the non fading. +6  6 is displayed as the level is increased or decreased.

2 Press c or d to select cut-off frequency. Each press of c or d selects cut-off frequencies in the following order: 5080125 (Hz) Only frequencies lower than those in the selected range are output from the subwoofer. 3 Press a or b to adjust the output level of the subwoofer. Each press of a or b increases or decreases the level of the subwoofer. +6  6 is displayed as the level is increased or decreased.

Using the high pass filter
When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn the HPF (high pass filter) on. Only frequencies higher than those in the selected range are output from the front or rear speakers. 1 Press AUDIO to select HPF. Press AUDIO until HPF appears in the display. 2 Press a to turn high pass filter on. HPF 80 Hz appears in the display. High pass filter is now on.

English

Using non fading output
When the non fading output setting is on, the audio signal does not pass through this units low pass filter (for the subwoofer), but is output through the RCA output. 1 Press AUDIO to select non fading output on/off setting. Press AUDIO until NonFad ON appears in the display.

# To turn high pass filter off, press b.

En

27