Troubleshooting Guide
The messages shown below display your systems condition.
EJECT: No disc magazine has been loaded in the changer. The disc magazine is not completely loaded. � Load the disc magazine properly. No CD in the unit. � Insert the CD. No disc has been loaded in the disc magazine. � Load a disc into the disc magazine. No disc has been loaded in the disc magazine. � Load a disc into the disc magazine. The CD is quite dirty. The CD is upsidedown. The CD is scratched a lot. � Clean the CD and load it correctly. The CD is upside-down. � Load the CD correctly. Nothing has been recorded on the MD. No tracks are recorded on the MD, although it has a title. Media was played that doesn�t have data recorded that the unit can play. � Use media that has data recorded that the unit can play. The faceplate of the slave unit being connected to this unit has been removed. � Replace it. Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason. � Check the disc magazine. And then press the reset button on the unit. If the "E-99" code does not disappear, consult your nearest service center. The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F), stopping all operation. � Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F), the disc will start playing again. Discs are being exchanged in the Disc changer. The unit is reading the data on the disc. IN (Blink): The CD player section is not operating properly. � Reinsert the CD. If the CD cannot be ejected or the display continues to flash even when the CD has been properly reinserted, please switch off the power and consult your nearest service center. A MP3/WMA is played with a format that this unit can�t support. � ---A copy-protected file is played. � ----
