Attaching the Rubber Packing
(if it is not already attached to the camera main unit)
� If rubber packing is not attached, it is necessary to first correctly attach the rubber packing before attaching the main unit cover. In this case, attach by following the procedure described below.
Dome Cover
Rubber Packing
Dome Cover (KA-C76)
Rubber Packing
Rubber Packing
Tab
Cross-section
Groove
Pipe
Dome Cover Rubber Packing Pipe
1. Attach the rubber
packing in the position shown in the illustration. Make sure that the rubber packing is parallel to the pipe.
2. Align the tab on the
dome cover with the groove on the pipe and fit the dome cover.
3. Move the rubber packing upward
as shown in the cross-section diagram. When performing this, do not remove the installed dome cover from the pipe. If the dome cover is removed, the rubber packing will drop inside the pipe and it will not be possible to re-attach the dome cover. If the rubber packing is not correctly attached, the dust- and drip-proof performance of the dome cover cannot be guaranteed.
