|
Usuarios conectados
Actualmente hay 5774 visitantes y 1 usuarios online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Controls
Delay/Resume
at a Glance
(continued)
The Delay/Resume option can be used to automatically start the cycle at a later time, such as during off-peak hours for reduced energy cost or to reduce daytime heat buildup in the home.
Note: If Delay is chosen without selecting acycle and/or options, the dishwasher will select the last Heavy, Normal or Light Wash used. (It will not remember Rinse Only.)
To Set Up a Delay:
� Select the appropriate cycle and options for the load. II, Press the Delay/Resume pad until the desired amount of delay time (2, 4 or 6 hours) is selected. The clock will begin when the pad is released, � The Delay Hours indicator light will remain lit until the delay time expires. � The cycle will automatically start as soon as the delay time expires.
To Cancel a Delay:
Wait at least 2 seconds, then press the Delay/Resume pad again. The indicator light will go out and the cycle will start or resume immediately.
Operating
Starting
clicks.
Tips
Dishwasher Adding a Forgotten Item
For best cleaning, the forgotten item should be added early in the cycle. ¢, Press the Delay/Resume pad or unlatch the door. � Wait for the water circulation to stop. � Open the door and add the item. ¢ Close and latch the door. � If Delay/Resume was pushed, push it again to restart the dishwasher. � After five seconds, the cycle resumes automatically a_ the point of interruption. Note: Extended interruption of the wash cycle is not recommended.
The
I_ After loading the dishwasher and adding detergent, close the dishwasher by pressing the door until the latch � To start the dishwasher, firmly press the desired cycle and options pads. (After a pause, the fill will begin.) To prevent unplanned cycle or option changes, these selections are "locked in" after 1 minute. � The indicator lights for the selected cycle and options will glow. � To cancel an option, press the pad again. To cancel a cycle, press the Drain/Off pad. Note: If a cycle or option pad is pressed after the selections are "locked in'', the indicator light above the Control Lock pad will flash five times.
|
|
|
> |
|