FRESH FOOD FEATURES
Shelves
CAUTION
To avoid personal injury or property damage, observe the following: � Never attempt to adjust a shelf that is loaded with food, except in the case of the ElevatorTM Shelf. � Confirm shelf is secure before placing items on shelf. � Handle tempered glass shelves carefully. Shelves may break suddenly if nicked, scratched, or exposed to sudden temperature change. Your refrigerator has either Spill-Catcher� or nonsealed shelves. Spill-Catcher� shelves have a spill retainer edge which allows for easier clean up and some are equipped with a slide out feature. To slide out (select models), grasp the front of the shelf and pull forward. Push in the shelf to return to the original position. To Remove a Shelf: � Slightly tilt up the front and lift up the rear of the shelf, then pull the shelf straight out. To Lock the Shelf Into Another Position: � Tilt up the front edge of the shelf. � Insert the hooks into the desired frame openings and let the shelf settle into place. � Be sure the shelf is securely locked at the rear. The Crisper Top serves as the lower fresh food shelf. To Remove the Crisper Top: � Place hand under the frame to push up the glass. Lift glass out. To Install: � Repeat above instructions in reverse order. To Slide Out Elevator� Shelf: � Grasp the front of the shelf and pull forward. � Push the shelf in to return to original position. To Adjust the Elevator� Shelf: � Pull out the knob on the crank handle. � Rotate the crank clockwise to raise the shelf, and counterclockwise to lower the height of the shelf. To Remove Elevator� Shelf: � Completely unload the shelf and pull the shelf forward. � Pull until the shelf stops. � Press up on the tabs located underneath its outside edges and continue pulling forward until the shelf is clear of the frame. To Replace Elevator� Shelf: � Align the shelf to the frame and push it all the way back. It is not necessary to press up on the tabs for reinstallation. In ordinary use, the Elevator� Shelf frame assembly does NOT require removal. Though unlikely, and not recommended, the correct removal procedure is as follows: To Remove Frame Assembly: � Unload the shelf completely. � Slide the shelf forward about 2� and manually move the two rear latches toward the shelf center. � While supporting the entire shelf and frame from underneath, lift slightly and rotate the assembly approximately 30° to allow the rear mechanism to clear the vertical rear side rails. � The entire assembly can then be moved forward and clear of the refrigerator compartment. To Reinstall Frame Assembly: � Reverse the removal procedure. Be sure the shelf is in a level position. When the sliding shelf is pushed to the rear, it will reposition the rear latches to their correct operating position.
Elevator� Shelf (select models)
The Elevator� Shelf is equipped with a spill-retaining edge and the EasyGlide� slide-out feature. It can be adjusted up or down without unloading.