KUPPERSBUSCH IKE197-7
Manual de Usuario

Building-in instructions
Dimensions of housing Model IKE 197-7 IKE 247-6 Height 1030 mm Depth Width 550 mm 560 mm 1225 mm 550 mm 560 mm

50 mm

min. 2 200 cm

Temperature regulation
The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings.
min. 200 cm2

Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.

However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: � room temperature; � how often the door is opened; � the quantity of food stored; � location of appliance. A medium setting is generally the most suitable.

For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction.

D567

Fresh food refrigeration
To obtain the best performance: � do not store warm food or evaporating liquids in the refrigerator; � do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it.

540

50

B
It is necessary that the niche is provided with a conduct of ventilation having the following dimensions: Depth 50 mm Width 540 mm
PR01

T

H

�

Fit the appliance in the niche by making sure that it stands against the interior surface of the unit on the side where the door hinges of the appliances are fitted. Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2).

Shelf holders
1
Yourappliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: Raise the shelf from the back, push it in the direction of the arrow until it is freed and remove the retainers.

A

B

2

D022

Fasten the appliance with 4 screws provided in the kit included with the appliance.

Movable shelves
The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired.

I

D338

Apply the sealing strip pushing it between the refrigerator and the adjacent cabinet.

Positioning the door shelves
To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.

D724

PRXXX

16

13